Liteguide Controller AE1000 - Nireco Vietnam

The Liteguide Controller AE1000 carries out EPC （Edge Position Control） through a combination of Photoheads （PH16B） and Ultrasonic Sensor （UH01）, CPC （Center Position Control） through a combination of Photoheads and Autowide Sensor （AWE280 etc.） and LFC （Line Follower Control） through a combination of LH19 and LH110.

Feature

Liteguide Controller AE1000 is the successor to the previously well established AE900E and AE900L controllers.
This single type can be connected to Nireco standard sensors which has been used with the AE900E or AE900L controller.
（Some sensors may need to be used with a preamp）
Can be used directly coupled with electrical actuators K12 and K61. Can also be connected to the K80 series through use of a driver.
Has 2 systems, a sensor input stage and a shift input stage, which can be switched for use.
Uses a larger LCD display than previous models with a white backlight making it both easier to see and allowing for verification of a greater amount of information.

Configuration

Specifications

Power Supply Voltage		AC100 to 240V 50/60Hz ±10%
Power Consumption		300 VA (inrush current 100 A 10 ms typical (200 V))
Power Fuse		250V AC, 3.15 A (time-lag type)
Ambient Operating Temperature		0 to 50°C
Ambient Operating Humidity		35 to 85% RH or lower (no condensation)
Vibration Resistance		3.5 mm, 1 G, 3 to 150 Hz, three-directions (1hour)
Power supply Noise		2.5 kVp-p, normal mode, common mode 50 ns, 1μs width
Usage atmosphere:		Area with no water, flammable or corrosive gases, and little dust.
Mass		Approximately 5 kg
IP Class		IP30
Input	2 Sensor systems	Voltage input Maximum ±5V（No input resistance） Current input 0-20mA (input resistance converted to 240/2kΩ)
	2 analog shift systems	Voltage input Maximum ±10V
	Centering	Proximity switch input （0-8V, 1.2kΩ input resistance）（Applies to: KL1632. 0-90P）
	Position Transmitter	Voltage input Maximum ±10V
	Photo coupler input （12V DC, 15mA）	Remote controller : Operation mode switching（auto / manual / centering） Operation keys （left / right / auto balance / reverse） System selection（EPC1 / EPC2） Locks 3 points Actuator end limit : 2 points
Output	Electrical actuator	K12 ±24V DC, 1A(maximum) or K62 ±36V DC, 2A(maximum)
	Lamp power source	4 to 12V DC, variable （maximum 1A）
	Fine tuner, Position transmitter, LH8B	±5V power source （maximum 0.1A）
	Sensors	±15V power source （+15V, 1A; -15V, 0.2A）（Note: The current capacity on the + side combined with the lamp power source in(2) is less than 1A.）
	Centering proximity switch power source	8V DC （maximum 30mA）
	2 indicator systems	Voltage output Maximum ±10V （load resistance 2kΩ or greater） Deviation output Position transmitter output
	Photo coupler output （24V DC, 40mA）	Remote controller : Operation mode state（auto / manual / centering） System state （EPC1 / EPC2） Alarms Excessive deviation End limit Actuator lock Actuator excessive load

LASER TYPE EPC SENSOR : SLH20B

Ultrasonic Autowide Senso : UHW500 / 700

LINE FOLLOWER HEAD : LH19

Compact Guide Roll Mechanism LCD series

Guide Roll Mechanism

Motor-Driven Actuator : A031

Motor-Driven Actuator : K80

Motor-Driven Actuator: K62 K62/A

Motor-Driven Actuator: K12 series

Liteguide Amplifier: AE61 series

Litegude Amplifier: AE120series

Liteguide Controller: AE1000

Liteguide Controller: AE500

Servoguide Mark-Ⅳ M-Series ELECTLIC-PNEUMATIC TYPE

Sensing Nozzle: SN12G / SN15

Electro-Pneumatic Converter: EN40

Tension Meter: TM310T

Tension Meter: TM340

Tension Controller: TC920V

Tension Controller: TC680A/D

Motor-Driven Actuator: A151

Line Follower Head LH500	Guide Roll Mechanism	Compact Guide Roll Mechanism LCD series
TC680A-D	K62 / K62A	TM310T	M721-AM
TC920V	K80 / K12	TM340	M550-AM
UHW051	AE61E / AE120	MC / MG	M220-AM
UHW280	PC300G	A151 / A031	M810-AM
UHW500/700	AE1000	A352 / EN40	LH110 / LH19
UH01 / SM9000	AE500 / SM23	MB25 / MB33	MC30 / LM200
MJ / TSA / MG050	D053B-A / GM6600/A	MG010 / MG020	MG100 / MG200
MB / CJ	SN12G / SN15	PH22	MB05 / MB11
MB11/33	M121-AM	NRC-01	SM5000

Bộ điều khiển lực căng Nireco – Nireco Vietnam – TMP Vietnam

Hệ thống kiểm tra chất lượng in màng Nireco – Nireco Vietnam – TMP Vietnam

Bộ đo vị trí Nireco – Nireco Vietnam – TMP Vietnam

Cảm biến chỉnh biên Nireco – Nireco Vietnam – TMP Vietnam

Cảm biến đo lực căng Nireco – Nireco Vietnam – TMP Vietnam

Bộ chỉnh biên LH110 - Nireco Vietnam - TMP Vietnam

Bộ chỉnh biên LH500 Nireco - Nireco Vietnam

Bộ điều khiển lực căng TC680A/D Nireco - Nireco Vietnam

Bộ điều khiển lực căng TC920V Nireco - Nireco Vietnam

Bộ điều khiển vị trí A031 ( A031-80-20 ; A031-150-20 ) Nireco - Nireco Vietnam

Bộ điều khiển vị trí A151 (A151-150-20; A151-200-20 ) Nireco - Nireco Vietnam

Bộ điều khiển vị trí A352-150-20 Nireco - Nireco Vietnam

Cảm biến chỉnh biên UH01 / UH01A Nireco - Nireco Vietnam

Cảm biến chỉnh biên UHW051 Nireco - Nireco Vietnam

Cảm biến chỉnh biên UHW500 / 700 Nireco - Nireco Vietnam

Cảm biến lực căng CJ200 / CJ500 / CJ1000 Nireco - Nireco Vietnam

Cảm biến lực căng MB05B / MB05A / MB11B / MB11A / MB25B / MB25A / MB33B / MB33A / MB41 Nireco - Nireco Vietnam

Cảm biến lực căng MC30A / MC30B / MC30C Nireco - Nireco Vietnam

Cảm biến lực căng MG010 / MG020 / MG050 / MG100 / MG200 Nireco - Nireco Vietnam

Cảm biến lực căng MJ050 / MJ200 / MJ500 / MJ1000 Nireco - Nireco Vietnam

Cảm biến lực căng TSA200 (MB11) / TSA1000 (MB25) / TSA010K (MB33, MB41) Nireco - Nireco Vietnam

LASER TYPE EPC SENSOR SLH20B Nireco - Nireco Vietnam

Đồng hồ hiển thị lực căng TM310T Nireco - Nireco Vietnam

Đồng hồ hiển thị lực căng TM340 Nireco - Nireco Vietnam

Nireco Vietnam	Design Position Controll DPC NIP100
Nireco Vietnam	Design Position Controll DPC NIC100
Nireco Vietnam	LINE FOLLOWER HEAD LH500
Nireco Vietnam	LINE FOLLOWER HEAD LH110
Nireco Vietnam	LINE FOLLOWER HEAD LH19
Nireco Vietnam	PHOTOHEAD PH30 / PH31
Nireco Vietnam	LASER TYPE EPC SENSOR SLH20B
Nireco Vietnam	Ultrasonic Autowide Sensor UHW500 / 700
Nireco Vietnam	Ultrasonic Autowide Sensor UHW28
Nireco Vietnam	Ultrasonic Autowide Sensor UHW051
Nireco Vietnam	ULTRASONIC SENSOR UH01 series
Nireco Vietnam	PHOTOHEAD PH22
Nireco Vietnam